OK so, I'm trying to get the orientation on this gun skin I'm working on, now, I checked the adjust pivot thing and I noticed it goes 0.50 units, so I was wondering, how I can go lower than that, say 0.25 or 0.05?
TL:DR
I want to be able to move the skin adjusting pivot offset setting, not 0.50, but maybe 0.25 or 0.05.
- Board index ‹ Main ‹ Help ‹ Modding Help
New Ace of Spades Forums: http://buildandshoot.com/
Slab 6 pivot help!
3 posts
• Page 1 of 1
Slab 6 pivot help!
by lavadeeto » Sat Aug 25, 2012 7:38 pm
- lavadeeto
- Member
- Posts: 12
- Joined: Tue Jun 26, 2012 5:12 pm
Re: Slab 6 pivot help!
by eXteeL1000 » Sat Aug 25, 2012 8:16 pm
YOU COULD ADJUST PIVOTS???
I am a proud member of SIDR and I am always ready to fight!
-
eXteeL1000 - Member
- Posts: 182
- Joined: Fri Jul 20, 2012 4:08 am
- Location: Red Deer, Alberta, Canada
Re: Slab 6 pivot help!
by SIMOX » Sat Aug 25, 2012 8:38 pm
When you enable "adjust pivots" move your mouse to the one of 3 little windows in the bottom left corner and use arrow keys to move the object. 1.00 is one block.
EDIT: Though i don't know if it's possible to move lover than 0.50 rate. Since every arrow key push skips through 0.50
EDIT: Though i don't know if it's possible to move lover than 0.50 rate. Since every arrow key push skips through 0.50
-
SIMOX - Moderator
- Posts: 1187
- Joined: Mon Dec 26, 2011 7:47 pm
- Location: Lithuania
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest